Short answer: A combi boiler suits most Glasgow flats and smaller houses with one bathroom and a good mains flow, and frees up the cylinder press. A system boiler with a cylinder suits bigger homes where two showers run at once. In a top floor tenement flat, test the mains flow before choosing a combi, because weak flow means a weak shower.
The combi or system question comes up on almost every new boiler survey we do in Glasgow. The answer depends less on the boiler and more on the home: how many bathrooms you have, how many people shower in the morning, and how good the water supply into your property is. A top floor flat in Hyndland and a four bedroom house in Bishopbriggs can need very different things.
The short version
| Combi boiler | System boiler and cylinder | |
|---|---|---|
| Hot water | Heated as you use it | Stored in a cylinder |
| Space needed | Boiler only | Boiler plus cylinder cupboard |
| Best for | One bathroom, smaller households | Two or more bathrooms used together |
| Depends on | Mains flow and pressure | Cylinder size and, if unvented, mains flow |
| Run out of hot water | No, but flow is limited | Yes, once the cylinder is used |
| Common in | Glasgow flats and smaller houses | Bigger suburban family homes |
How a combi works
A combi heats your radiators and your hot water from one box on the wall. There is no tank in the loft and no cylinder. When you turn on a hot tap, the boiler fires and heats mains water as it passes through. You never run out, but there is a limit to how much hot water it can give at once.
That limit is set partly by the boiler’s size and partly by how much cold water reaches it. A combi cannot give you more hot water than the mains supplies.
The tenement problem: flow on the top floor
Glasgow has around 70,000 pre-1919 tenement flats, according to Glasgow City Council. Many in the West End, around Partick, Hyndland and Hillhead, are four storeys high. The supply often comes into the building at ground level and rises through the close or up the back to each flat. In older buildings that riser can be narrow, old and shared.
On the ground floor, flow is usually fine. On the top floor, it can drop a lot, especially when the flats below are using water. Some top floor flats are still fed from an old tank in the roof space.
That is why we measure the flow rate at the kitchen tap before recommending a combi for a top floor flat. If the flow is good, a combi works well and is the simplest choice. If it is weak, the options are:
- renew the supply pipe into the flat, if the weak point is on your section
- keep stored hot water, so the shower does not depend on mains flow
- choose a combi sized for the flow you actually have, accepting a gentler shower
A shower pump does not fix this on a combi. Pumps are made for stored water, and Scottish Water’s byelaws restrict pumps that draw straight from the mains. Our shower pump guide explains when a pump does make sense.
How a system boiler works
A system boiler heats the radiators and a hot water cylinder. The hot water is stored, so several taps and showers can run at once until the cylinder is used up. Then it takes time to reheat.
Most system boilers today are paired with an unvented cylinder, which stores hot water at mains pressure. That gives strong showers on every floor, as long as the mains flow into the house is good. It is common in larger homes in Bearsden, Milngavie and Newton Mearns. Scottish building standards say unvented cylinders should be installed by someone with appropriate training, under standard 4.9 of the domestic technical handbook.
Regular boilers
A regular boiler works with a cold water tank, usually in the loft, and a vented cylinder. Pressure comes from gravity, so it is lower unless pumped. It is still the right answer in some older homes, especially where the existing pipework was designed for it and a tank is already in place. In tenements, the roof space is often shared, so a tank in the loft raises its own questions about access and ownership.
What happens to the press cupboard
Many Glasgow flats still have a copper cylinder in a press, often in the hall. Switching to a combi frees that cupboard for storage. It also removes the immersion heater, the old cold tank if there is one, and the pipework to them. That is a popular change, but it is more work than a straight boiler swap. It needs pipe changes, new controls and making good where the old pipes ran.
Soft water and boiler choice
Scottish Water’s 2024 hardness figures put the Milngavie supply zones at about 16 mg/l, classed as soft. In hard water areas, scale builds in a combi’s hot water heat exchanger and is a big factor in boiler choice. In Glasgow it is far less of one. You can choose on space, demand and flow.
Flue position
In a tenement flat the flue route can decide where the boiler goes. Kitchens on the back wall usually allow a balanced flue straight out. A front elevation in the Glasgow West conservation area, or a boiler moving into the old cylinder press, needs more care. Our new boiler page covers flues and the rules in Scotland.
How we decide on a survey
We look at the number of bathrooms and people, how they use hot water, the mains flow and pressure, the space, the flue route and the condition of the radiators. Then we explain the options in plain terms and give a written quote. For more on flats in the West End, see our West End area page.
Quick questions
Is a combi boiler good for a tenement flat?
Often yes, if the mains flow and pressure into the flat are good enough. On a top floor with an old narrow supply, test the flow first.
Can a combi run two showers at once?
Most combis can only give a strong flow to one outlet at a time. If two showers run together often, stored hot water usually works better.
Can I swap my cylinder for a combi?
Yes, it is a common change in Glasgow flats. It frees up the press cupboard. The pipework and controls need changing too.
What is a regular boiler?
Also called heat only, it works with a cold water tank and a vented cylinder. It still suits some older homes.
Last updated 23 October 2026. Written for homes in Glasgow. Rules can change, so check the linked sources for the latest position.