Boiler repair
Boiler repair in Glasgow
If your boiler has stopped, check the pressure gauge, the power and, in a cold snap, the condensate pipe outside. Low pressure and a frozen condensate pipe are the two most common causes in Glasgow. Anything inside the boiler casing is gas work and must be done by a Gas Safe registered engineer.

You need this when
- No heating, no hot water, or both
- Pressure gauge below 1 bar, or it keeps dropping
- A fault code or flashing light on the display
- Gurgling from the boiler or a frozen pipe outside in cold weather
- Banging, whistling or kettling noises
- Water dripping from the boiler or its pipes
Common boiler faults in Glasgow
Frozen condensate pipes. Condensing boilers, which is nearly every gas boiler fitted in recent years, produce waste water that runs through a plastic condensate pipe, often outside to a drain. In a Glasgow frost that pipe can freeze, the boiler backs up and locks out, often with a gurgling noise. The Met Office records about 46 days of air frost a year at Glasgow Bishopton, so this happens every winter. Our frozen condensate pipe guide explains the safe fix.
Low pressure. Combi and system boilers run sealed heating systems that need about 1 to 1.5 bar when cold, as most manufacturers set out in their manuals. If the pressure falls, the boiler stops. Topping up through the filling loop fixes it for now, but if it keeps falling there is a leak or a faulty valve.
Failed parts. Diverter valves, fans, pumps, printed circuit boards and gas valves wear out. Glasgow's soft water means scale is a smaller factor than in hard water areas, so faults are more often wear, sludge from old radiators, or electrical.
Look at the pressure gauge. If it is below about 1 bar, the manual will show how to top up through the filling loop. Check the thermostat is calling for heat and the timer is on. Check other gas appliances work, such as a gas hob, to rule out the gas supply or a prepayment meter running out. In a frost, check the condensate pipe outside. If none of these is the cause, write down the fault code and the boiler make and model, which helps the engineer bring the right part.
Gas safety
In Great Britain, anyone working on gas appliances must be on the Gas Safe Register. Ask to see the engineer's Gas Safe ID card. The back of the card lists the types of gas work they are qualified for, and you can check the number on the Gas Safe Register.
If you smell gas, open windows, do not use switches or flames, turn off the gas at the meter if you can, leave and call the National Gas Emergency Service on 0800 111 999. If your carbon monoxide alarm sounds, get fresh air and call the same number.
Repair or replace?
A repair usually makes sense when the boiler is not very old, parts are available and the fault is a single component. Replacement starts to make sense when parts are hard to get, repairs are becoming regular, or the boiler is an old non condensing model. We give you the honest view, and if replacement is the better choice, our new boiler page explains the options in Scotland.
Servicing and landlords
A yearly service keeps a boiler running safely and is usually needed to keep a manufacturer's warranty. For private landlords in Scotland, the Repairing Standard requires gas appliances to be checked every year by a Gas Safe registered engineer, with a copy of the Landlord Gas Safety Record given to the tenant. A carbon monoxide detector is also needed in any space with a carbon fuelled appliance such as a boiler.
What affects the price
The price depends on the fault, the boiler make and model, the part, and access to the boiler, for example in a high kitchen cupboard or a loft. We confirm the price after diagnosis and before the repair.
| What | Price |
|---|---|
| Boiler fault diagnosis | price confirmed after a look at the job |
| Replacement part and fitting | quote on survey |
| Annual boiler service | quote on survey |
| Landlord gas safety check | quote on survey |
No prices are shown on this site. Every job is priced after a look at it, by photo or a visit.
The visit
What happens, step by step
- 01
Quick checks on the phone
We go through pressure, power, the thermostat, the gas supply to the cooker and the condensate pipe, which can fix it without a visit.
- 02
Diagnose
A Gas Safe registered engineer reads the fault code, tests the components and checks gas pressure and flue safety.
- 03
Price the repair
We explain the fault and the part, and whether repair or replacement makes more sense for the boiler's age.
- 04
Repair and safety check
Parts fitted, combustion and flue checked, and the system tested on heating and hot water.
FAQ
Boiler repair: what people ask
Why does my boiler keep losing pressure?
Usually a leak on the heating system, at a radiator valve or pipe, or a faulty pressure relief valve. Bleeding radiators also lowers pressure, so top up after bleeding.
My boiler stopped in the frost and is gurgling. What is wrong?
Most likely a frozen condensate pipe. Pour warm, not boiling, water along the outside section, then reset the boiler.
Can a plumber repair my gas boiler?
Only if they are Gas Safe registered for that type of appliance. Check their ID card and the register.
How often should my boiler be serviced?
Once a year is the usual advice from manufacturers. Landlords in Scotland must have gas appliances checked every year.
Where