Short answer: A leaking shower is usually one of four things: a failed silicone seal, cracked or porous grout, a loose or cracked waste, or a leak at the valve or pipes behind the wall. Test them in that order, cheapest first. If water is already staining the ceiling below, stop using the shower until the cause is found.
In a two storey house in Bishopbriggs, the bathroom is usually upstairs, above the hall or the kitchen. When the shower leaks, you see it as a brown stain on the ceiling below, or worse, water dripping from a light fitting. The shower may look perfect from inside the cubicle. The water is getting out somewhere you cannot see.
The good news is that most shower leaks have one of a small number of causes, and you can rule several out yourself before anyone lifts a tile.
The four usual causes
| Cause | Typical sign | Fix |
|---|---|---|
| Failed silicone seal | Gaps, black mould or lifting silicone at the tray or bath edge | Remove all old silicone, dry, reseal |
| Cracked or porous grout | Dark grout lines, loose tiles near the tray | Regrout or reseal tiles |
| Waste leak | Leak only when water drains, often directly below the plughole | Tighten or replace the waste |
| Valve or pipe leak | Leak even when the shower is off, or behind the wall | Repair the valve or pipe joint |
Test it in order
Do these one at a time, with a towel on the floor below and someone downstairs watching the ceiling.
1. The waste. Put the plug in if there is one, or block the waste, and fill the tray with a few centimetres of water. Then let it drain. If the ceiling only gets wet as it drains, the waste joint is the culprit.
2. The tray or bath edge. Pour water along the seal line only, using a jug, without wetting the tiles. If that produces the leak, the seal is failing.
3. The tiles and grout. Spray the tiled walls only, using the shower head pointed at the wall, keeping water off the tray edge. A leak now points to grout or a gap at the shower screen.
4. The valve and pipes. If none of the above causes a leak, or the stain grows when the shower is off, the problem is likely behind the wall at the mixer valve or its pipe connections. That needs a plumber.
Why upstairs showers leak more
Many Bishopbriggs homes from the 1950s to the 1970s have timber floors upstairs. Timber flexes. A shower tray sitting on joists without a solid, level board under it moves a fraction every time someone stands in it, and that movement breaks the silicone and can crack the tray. En suites added later, often in small spaces, are especially prone to this.
When we fit or refit a tray, we put it on a solid, level base and use a sealant that allows for some movement. In a wet area we also waterproof the walls and floor behind the tiles, which is often called tanking. Tiles and grout are not waterproof on their own.
Glasgow’s water and your shower
Glasgow’s water is soft. Scottish Water’s 2024 hardness data puts the Milngavie zones at about 16 mg/l as calcium carbonate. Shower heads and valves rarely seize with scale here, so a leak from the valve is more often a worn cartridge or O ring than scale damage. Soft water also means silicone stays clean of scale, but mould still grows where seals stay damp.
Act quickly, especially in flats
A slow leak soaks into the joists and plaster before it shows. If you are in a flat, the water may reach a neighbour’s ceiling first. In a tenement, lath and plaster ceilings can hold water and then sag. If the ceiling below bulges, keep people out of the room.
For landlords, a long running leak can lead to damp and mould, which the Repairing Standard now covers with specific timescales. mygov.scot says landlords must inspect within 10 working days of being told and start repairs within 5 working days of the inspection where damp or mould is substantial.
When it is time for a new shower area
If the tray is cracked, the tiles are loose or the walls behind are soft, patching will not last. Replacing the shower area properly means taking it back to the walls, fixing the base, waterproofing and refitting. That is often the moment people switch a bath to a walk in shower. In a house, that usually needs no building warrant, but check the rules in our building warrant guide.
If you are in Bishopbriggs, our Bishopbriggs page explains the housing we work in there, and our bathroom and shower page covers refits from survey to handover.
Neighbours and shared walls
In a semi, the bathroom wall may back onto your neighbour’s house. A leak from a shower valve on that wall can show as damp on their side before it shows on yours. If a neighbour mentions a damp patch that lines up with your bathroom, check the valve and pipes behind the shower first.
Quick checklist
- Stop using the shower if the ceiling below is wet
- Test waste, seal, tiles, then valve
- Photograph the stain and the shower for your records
- Check the tray does not flex
- Call a plumber if the leak happens with the shower off
Quick questions
Why does my ceiling only get wet when someone showers?
That points to the shower itself: the seal, grout, tray or waste. A leak on the supply pipes would usually show even when the shower is off.
Can I just reseal the shower myself?
You can, but the old silicone must be fully removed and the surface dry first. Resealing over a leaking waste or cracked tray will not fix it.
My shower tray flexes when I stand in it. Is that a problem?
Yes. Movement breaks the seal and can crack the tray or loosen the waste. The tray needs a solid, level base.
Does insurance cover a leaking shower?
It depends on your policy. Some cover the damage but not the repair of a worn seal. Keep photos and a plumber's note of the cause.
Last updated 23 October 2026. Written for homes in Glasgow. Rules can change, so check the linked sources for the latest position.