Short answer: To protect an outside tap in winter, turn off its isolation valve inside the house, open the outside tap to drain the pipe and leave it open until spring. Fit an insulated cover. If there is no inside valve, have one fitted. A full outside tap is one of the first things to freeze in Glasgow.
Outside taps are small, cheap and easy to forget. They are also one of the most common places for a pipe to freeze and split in a Glasgow winter. In Bearsden, where many homes have long gardens, garages and taps on outside walls well away from the heating, it is worth ten minutes in October to deal with it.
Why outside taps freeze first
An outside tap sits on the coldest side of the house with nothing between it and the weather. The short pipe that runs through the wall to feed it is also cold, and the water in it is still. Still water freezes much sooner than water that moves.
Glasgow is not the coldest part of Scotland, but it does freeze. The Met Office’s long term averages for Glasgow Bishopton show about 46 days of air frost a year, with around 10 in each of December and January. Suburbs on higher or more open ground, such as parts of Bearsden and Milngavie, can feel it more.
When water freezes it expands. In a pipe that has nowhere to go, the ice can split the pipe or the tap body. You usually do not find out until the thaw, when water starts running down the wall or, worse, inside it.
Step by step: winterising an outside tap
- Find the isolation valve inside. Follow the pipe from the outside tap back through the wall. Most installers fit a small valve inside, often under the kitchen sink, in a utility room or in the garage. It may be a lever valve or a small screw valve you turn with a flat screwdriver.
- Turn the valve off. A lever valve is off when the lever is across the pipe. A screw valve is off when the slot is across the pipe.
- Open the outside tap. Let it run until it stops. That drains the short section of pipe outside the valve.
- Leave the outside tap open. If any water is left, it has room to expand.
- Fit an insulated cover. A foam or padded cover over the tap body adds a layer of protection.
- Disconnect hoses. A hose left on the tap holds water, and the fitting can split.
Some outside taps have a drain off point next to the inside valve. If yours does, open it with a bucket under it after closing the valve.
If there is no inside valve
Older installations, and some fitted by the owner years ago, have no isolation valve. The only way to drain the tap is to turn off the whole house at the stop tap. That is not practical for the whole winter.
Fitting an isolation valve is a small job. While we are there, we check the pipe through the wall is lagged, that it falls slightly towards the tap so it drains, and that the tap has a double check valve. That small valve stops garden water or hose water being drawn back into the drinking supply. Protecting the supply against that kind of backflow is covered by Scottish Water’s byelaws.
Frost proof outside taps
If your tap freezes every winter, a frost proof outside tap is worth considering. The valve that shuts off the water sits inside the warm wall, and the part outside drains when you close it. It still needs the hose taking off, but it removes most of the freezing risk.
If your outside tap has frozen
If the tap gives no water in a frost, it is frozen. Scottish Water’s advice on frozen pipes applies here too. Turn off the supply, then thaw gently with a hot cloth or hot water bottle. Never use a flame or a blowtorch. Our full guide to thawing frozen pipes safely has more detail.
Once it thaws, check for leaks before you leave the supply on. Look:
- at the tap body for cracks or drips
- at the wall around the pipe
- inside, under the sink or in the garage, along the pipe run
If water is coming from inside the wall, the pipe has split behind the brickwork or stone. Turn it off and get it repaired before using the tap again. Our burst and frozen pipes service covers this.
Garages, utility rooms and other cold spots
The outside tap is often a warning sign. If it froze, ask what else is on that wall. Common cold spots in Bearsden and similar suburban homes include:
- washing machine pipes in an unheated garage or utility
- pipes running through a garage to an extension
- pipes in lofts, especially over 1930s bungalows
- cold water tanks in lofts on older systems
Lag pipes in those places with proper pipe insulation, and keep some heat on in cold spells. Our guide on how to stop pipes freezing covers the rest of the house.
Quick checklist for October
| Job | Done |
|---|---|
| Hose off and stored | |
| Inside valve found and closed | |
| Outside tap opened and drained | |
| Insulated cover fitted | |
| Garage and utility pipes lagged | |
| Stop tap tested and working |
We look after homes across Bearsden, Milngavie and the north of Glasgow. See our Bearsden area page for more on the local homes and their plumbing.
Quick questions
Do I need to turn off my outside tap in winter?
Yes, if you can. Turn off the inside isolation valve and drain the outside section so there is no water left to freeze.
Where is the isolation valve for my outside tap?
Usually on the pipe inside the house where it goes through the wall, often under the kitchen sink or in a utility room or garage.
Is an insulated tap cover enough on its own?
It helps in a light frost but will not protect the pipe through the wall in a hard one. Isolating and draining is the reliable fix.
My outside tap leaks from the wall after a frost. What now?
The pipe has probably split inside the wall. Turn off the isolation valve or stop tap and get it repaired before using it again.
Last updated 23 October 2026. Written for homes in Glasgow. Rules can change, so check the linked sources for the latest position.