For one plumber in Glasgow

Own plumberinglasgow.co.uk and this website

  • The domain plumberinglasgow.co.uk
  • A search report: what people in Glasgow type for this trade each month
  • This website, with your own job photos in place of ours
  • Your Google Business Profile set up
  • 2 weeks of Google Ads management free (you only pay Google for the clicks)

Message Matthew at BetterWays, who own the domain.

See the search report for Glasgow

Glasgow and the towns around it

Get a free quote

Burst and frozen pipes

Water hammer and noisy pipes: what causes the banging

Last updated 23 October 2026 · 4 minute read

Short answer: Water hammer is the bang you hear when water moving through a pipe is stopped suddenly, usually by a fast closing valve on a washing machine, dishwasher or quarter turn tap. Loose pipe clips make it louder. Fixes include securing pipes, fitting an arrestor or a flexible hose, and replacing worn washers or valves.

Close up of a soldered copper pipe tee joint against a dark background

What water hammer actually is

Water in a pipe is heavy and it moves fast when a tap is open. If something stops it in an instant, the moving water has nowhere to go. The energy turns into a pressure wave that travels back along the pipe and makes it jump. That is the bang, thud or shudder you hear.

The sharper the stop, the bigger the bang. Old screw down taps close gradually, so they rarely cause it. Modern quarter turn taps, single lever mixers and the solenoid valves inside washing machines and dishwashers close almost instantly. That is why many homes only start banging after a new kitchen or a new appliance goes in.

Why it is common in older Rutherglen and Glasgow homes

Rutherglen’s red sandstone tenements on and around Main Street, and the older tenements in Cambuslang, often have pipework from several eras. Original runs may be clipped to joists with old fixings that have worked loose. Later repairs added copper or plastic in between. Long straight runs along a tenement floor carry a lot of moving water, and a loose pipe in a timber floor acts like a drum.

The council houses built between the wars and after in both towns have their own pattern. Original copper is usually sound, but old gate valves and stop tap washers wear, and a loose washer can chatter as water passes. Newer homes near the Clyde Gateway area tend to have plastic pipe, which absorbs shock better but can still knock if it is poorly supported.

Telling the noises apart

Not every noise is water hammer. Working out which one you have points to the right fix.

NoiseWhen it happensLikely cause
Single loud bangJust after a tap or appliance valve shutsWater hammer
Repeated knocking that fadesAfter the washing machine or a toilet fill valve shutsWater hammer with loose pipes
Rapid chattering or judderingWhile a tap is partly openWorn washer or loose valve part
Creaking or tickingAs the heating warms up or cools downPipes expanding against joists
Humming or whistlingWhile water is flowingPartly closed valve or worn stop tap
GurglingFrom the boiler or radiatorsAir in the heating, or a frozen condensate pipe in a frost

If the noise comes with the heating, read our guidance on the heating side instead. A gurgling boiler in a Glasgow cold snap is often a frozen condensate pipe, explained in our frozen condensate pipe guide.

Fixes that work

Secure the pipes. The cheapest fix is often clipping loose pipes properly, especially near the appliance or tap that triggers the bang. In a tenement that may mean lifting a floorboard or two.

Fit a water hammer arrestor. This is a small sealed device with an air cushion or spring inside, fitted on the pipe near the valve that causes the shock. It absorbs the pressure wave.

Use a flexible connection. A short braided flexible hose between the pipe and a washing machine or dishwasher valve takes some of the shock.

Replace worn washers and valves. A chattering tap or stop tap often just needs a new washer or a new valve. While we are there, we check the stop tap still shuts properly, because you need it in an emergency. Our stop tap guide explains where to find it in a tenement.

Check the pressure. If the incoming mains pressure is high, a pressure reducing valve can calm the whole system. We measure the pressure first, because in a top floor tenement flat it is more often too low than too high.

Toilet fill valves. Some fill valves shut with a snap. Swapping to a different type or adjusting it can stop the knock that follows every flush.

Why it is worth fixing

Each bang is a pressure spike through the whole run of pipe. Over months and years that strains soldered joints, compression fittings and push fit joints. It can loosen fittings under floors where you cannot see them, and a slow leak in a tenement floor can show up later as a stain on a neighbour’s ceiling.

If the banging comes with any sign of water, such as damp boards, a stain below or a meter style test showing water moving when everything is off, treat it as a leak first. Our burst and frozen pipe service covers repairs and replacing old pipe sections.

Old pipes and lead

Some older Rutherglen and Glasgow homes still have lead or old iron supply pipe. Scottish Water says homes built before 1970 have a higher chance of lead pipework, and lead service pipes were phased out in the 1960s and became illegal in 1969, according to its lead pipes page. Lead is soft and should not be battered by repeated shocks. If we find it while sorting a noise problem, we will tell you and can quote to replace it. The supply pipe from the boundary stop cock into your home is the owner’s responsibility.

Rutherglen and Cambuslang

Noisy pipes are one of the more common calls in older Rutherglen and Cambuslang homes, along with running toilets and winter bursts. Our Rutherglen and Cambuslang page covers the housing and the council, South Lanarkshire, which handles building standards there.

Quick questions

Is water hammer dangerous?

It is not usually an emergency, but each shock strains joints and fittings. Over time it can loosen joints and cause leaks, so it is worth fixing.

Why do my pipes bang when the washing machine fills?

The machine's inlet valve snaps shut, stopping the water instantly. A short flexible hose or a small arrestor near the valve usually cures it.

Why do my pipes knock when the heating comes on?

That is usually the pipes expanding as they warm and rubbing on joists or clips. It is a different problem from water hammer, fixed by easing the pipe where it is tight.

Can high water pressure cause banging?

Yes. Higher pressure makes the shock bigger. In some homes a pressure reducing valve on the incoming supply helps.

The serviceBurst and frozen pipes in Glasgow Local notesPlumber in Rutherglen and Cambuslang

Last updated 23 October 2026. Written for homes in Glasgow. Rules can change, so check the linked sources for the latest position.